Back to Home

Pulse energy, repetition rate, pulse width

EO-1064-PS 1064 nm near-infrared mode-locked high-power pulsed laser

1064 nm
  • The EO-1064-PS is a 1064 nm picosecond diode-pumped solid-state laser.
  • Pulse energy: 1–150 μJ at 200 kHz
  • Average power: 5–20 W at 1 MHz
  • Pulse width: <15 ps
  • Repetition rate: 1–1000 kHz
  • Operating mode: Mode-locked

Specifications

EO-1064-PS

22 specification rows

Wavelength (nm)1064
Operating modeMode-locked
Pulse energy1–150 μJ at 200 kHz
Repetition rate1–1000 kHz
Pulse width<15 ps
CoolingWater cooled
Average power5–20 W at 1 MHz
Configuration notesThe repetition-frequency specification is 1–1000 kHz in the model datasheet. Energy is specified at 200 kHz and average power at 1 MHz.
Power stability<5%, <3%
M²≤1.3
Pointing stability over temperature (urad/℃)<50
Polarization100:1
Beam diameter (mm)1.5±0.5
Beam divergence, full angle (mrad)≤2
Warm-up time (minutes)<15
Operating temperature (℃)15-30
Relative humidity<60%
Power supply (110/220VAC)PSU-EO-PS
Expected lifetime (hours)>10000
Elipticity>85%
Control modeGate/burst/INT control
Beam height from base plate (mm)87 (EO-1064-PS-I); 90 (EO-1064-PS-II)

Select energy and timing together

  • Match pulse energy, repetition rate, duration, trigger and cooling for one configuration.
  • Maximum energy and maximum repetition rate may describe different variants.
  • The repetition-frequency specification is 1–1000 kHz in the model datasheet. Energy is specified at 200 kHz and average power at 1 MHz.
Compare high-energy laser models →

What do you need?

  • Pulse energy
  • Pulse width
  • Repetition rate
  • Trigger and synchronization
  • Cooling
  • Beam delivery (free-space or fibre)

Model selection

Nearby series comparison

Compare EO-1064-PS with the closest available models in the Pulsed Lasers family.

Selection parameterEO-1064-PS (current)FS-H-1064AFS-H-1064B
Wavelength1064 nm1064 nm1064 nm
Optical power / pulse energy5–20 W at 1 MHz1-500 mW500-5000 mW
Operating mode / pulse widthMode-lockedPulsedPulsed
Beam quality≤1.3<1.2<1.2