Technology guide
Transimpedance amplifiers: converting detector current to voltage
Choose gain, noise, stability and output range around the actual photodetector and acquisition system.
- 01Detector current
- 02Feedback amplifier
- 03Analog voltage
- 04ADC
How it works
- A transimpedance amplifier converts an input current into an output voltage. Its feedback network sets the low-frequency current-to-voltage gain.
- Detector capacitance, amplifier input behaviour and feedback compensation affect stability and bandwidth. Gain cannot be selected independently of the detector.
- Noise includes contributions from the detector, feedback elements and amplifier. Compare integrated noise in the bandwidth the experiment actually uses.
- An analogue bandwidth specification does not establish a digital sampling rate. The ADC, anti-alias filter and calibration remain separate parts of the acquisition chain.
What to compare
| Parameter | Check in the specification |
|---|---|
| Transimpedance | Keep units of voltage per current and the selected gain range. |
| Bandwidth | Use the response for the actual gain and input capacitance. |
| Output range | Check offsets, supply rails and saturation for both signal and background. |
| Acquisition | Match ADC input range, coupling and sample rate to the analogue output. |
Integration
- Specify expected detector current, capacitance and useful frequency range.
- For quadrant detectors, keep sum, difference and any subsequent normalisation functions distinct.
- Use the actual readout board documentation rather than assuming a particular amplifier IC or feedback resistor.
Related products
- QPD board
Readout board: Transimpedance readout with analog sum and difference outputs for a quadrant-photodiode measurement.
- ZAMP-A / ZAMP-B
References
Discuss the configuration. Send the signal range, bandwidth, timing and electrical interfaces.