Technology guide
Measurement signal chains: sensor, readout and digitisation
Keep the measured physical quantity, conversion electronics and digital acquisition as separate parts of an instrument specification.
- 01Physical signal
- 02Sensor
- 03Analog readout
- 04Digital acquisition
How it works
- A sensor converts a physical input into a measurable signal. Amplification, filtering and digitisation then determine how that signal is recorded.
- Bandwidth belongs to a particular stage and operating condition. A fast ADC does not extend a slower sensor or amplifier response.
- Gain and noise must be referred to a defined point in the chain. Output-voltage noise and equivalent input noise cannot be compared without the conversion gain.
- Calibration connects recorded values to physical units. It does not remove every systematic error or replace checking linearity and operating limits.
What to compare
| Parameter | Check in the specification |
|---|---|
| Measurand | State the physical quantity, range and required uncertainty. |
| Interfaces | Match voltage, current, impedance and coupling between stages. |
| Bandwidth | Define the useful signal band and filtering before choosing sample rate. |
| Timing | Include trigger alignment, clock stability and event latency where relevant. |
Integration
- Draw the complete path from the optical or mechanical input to saved data.
- Keep supplied hardware and required external readout separate.
- Use exact-model documentation when a sensor head, amplifier board and complete instrument have different specifications.
Related products
- Lab Platform
Body and platform: Hard Aluminum.
- LumiSolarCell EL PL IR
- LumiSolarCell EL PL Rs
References
Discuss the configuration. Send the signal range, bandwidth, timing and electrical interfaces.