Pulse energy, repetition rate, pulse width
FS-G- 1030A1030 nm near-infrared pulsed laser
1030 nmFS-G- 1030A is a 1030 nm Pulsed laser. Used for sapphire marking, ceramic cutting, semiconductor cutting, film scribing. Key specifications: operating mode Pulsed, output / average power 1-10 W, repetition rate 50 kHz-1 MHz. View specifications, datasheet and enquiry options from Precisometer.
Specifications
FS-G- 1030A
23 specification rows
| Operating mode | Pulsed |
|---|---|
| Output / average power | 1-10 W |
| Repetition rate | 50 kHz-1 MHz |
| Pulse duration (fs) | <800 |
| Warm-up time (minutes) | <10 |
| Transverse mode | TEM00 |
| M2 factor | <1.3 |
| Polarization ratio | >100:1 Vertical |
| Cooled method | Water cooled |
| Operating temperature (℃) | 15-35 |
| Power supply (100-240VAC) | RAD1PS |
| Expected lifetime (hours) | >10000 |
| Pulse width | <800 @200KHz |
| Wavelength (nm) | 1030±5 |
| Average power (W) | 1-10 (10W@200kHz) |
| Single pulse energy ( μJ) | 1-100 (100μJ@50kHz) |
| Rep. rate (kHz) | 50-1000 |
| Peak power (MW) | 1-125 |
| Ave power stability (rms, 4 hours±3℃) | <2%, <1% |
| M² | <1.3 |
| Beam divergence, full angle (mrad) | <1.0 |
| Beam diameter at the aperture (1/e2,mm) | <3 |
| Beam height from base plate (mm) | 110 |
Applications
Uses named on this model’s datasheet.
- Sapphire marking
- Ceramic cutting
- Semiconductor cutting
- Film scribing
Need this configured?
Share wavelength, operating mode, output power or pulse energy, linewidth or pulse width, delivery, control, and safety requirements and we will qualify the matching configuration and lead time.
Related pulsed lasers
Compare the FS-G- 1030A with nearby pulsed lasers across the wavelength range.
