Technology guide
InGaAs detectors: spectral range and readout
Choose an InGaAs detector around the actual response band, active geometry and measurement bandwidth.
- 01Infrared light
- 02InGaAs absorption
- 03Charge collection
- 04Readout
How it works
- Indium gallium arsenide is a semiconductor detector material used for near-infrared and short-wave-infrared measurements. Absorbed photons create carriers that are collected electrically.
- Composition and detector construction determine the response limits. Standard and extended-wavelength devices must not be assigned the same cutoff or dark-current behaviour.
- Single photodiodes, line arrays and area imagers serve different measurements. CMOS readout circuitry can be attached to an InGaAs array without making the photosensitive material a silicon CMOS sensor.
- Cooling can reduce dark signal, but the required cooling and detector bias are device-specific.
What to compare
| Parameter | Check in the specification |
|---|---|
| Response band | Use the complete responsivity or quantum-efficiency curve at the working temperature. |
| Active geometry | Match spot size or image dimensions to the sensitive area, pixel pitch and optical magnification. |
| Readout mode | Separate image frame rate from photodiode electrical bandwidth and amplifier gain. |
| Noise conditions | Compare dark current, read noise and detectivity under the same bandwidth and temperature. |
Integration
- Keep the beam inside the active area and check the window and lens transmission over the selected band.
- Confirm detector bias, amplifier termination and cooling requirements before integration.
- For imaging, check the interface payload and exposure mode as well as the infrared response.
Related products
- SWIR1302KMB-E0417-U200
Detector assembly: China-made 1280 × 1024 sensor.
- Cooled VGA SWIR
Detector assembly: 640 × 512 InGaAs; 15 µm pixels.
- Cooled VGA Vis-SWIR
Detector assembly: 640 × 512 InGaAs; 15 µm pixels.
References
Discuss the configuration. Send the wavelength, signal level, active area and bandwidth requirements.