Back to Home

Technology guide

Camera sensors and readout: choosing the signal chain

Start with photons, sampling and acquisition timing, then choose detector architecture and readout around the measurement.

  1. 01Optical image
  2. 02Sensor
  3. 03Readout
  4. 04Recorded data
Conceptual operating path.

How it works

  • CCD, CMOS and InGaAs describe different aspects of a detector. CCD and CMOS commonly identify readout architectures; InGaAs identifies a photosensitive material.
  • A camera adds electronics, interfaces and mechanical packaging around the sensor. Shared chip identity does not make complete cameras equivalent.
  • Exposure mode establishes when light is collected. Readout speed establishes how the stored signal is transferred and digitised.
  • The useful image depends on the entire optical path, including spectral transmission, magnification and background rejection.

What to compare

ParameterCheck in the specification
Signal budgetEstimate detected photons, background and exposure before choosing a low-noise mode.
SamplingMatch pixel pitch to magnification and the smallest feature that needs resolving.
Data rateCheck sustained frame payload, cable interface and recording capacity.
EnvironmentConfirm temperature, vacuum or radiation requirements for the complete camera, not just the sensor.

Integration

  • Use the exact camera's spectral curves and timing diagrams.
  • Choose CCD, CMOS or InGaAs only when the documented device architecture and band match the experiment.
  • Prepare wavelength, field of view, exposure and trigger requirements when comparing configurations.

Related products

References

Discuss the configuration. Send the wavelength, field of view, exposure and trigger requirements.