Fiber Optical Amplifiers EDFA
Wide Temperature EDFA Amplifier -40 to 70 °C
Our Erbium doped fiber amplifier (EDFA) provides cost-effective solutions for high power optical amplification. It is built using semiconductor lasers, WDM, isolator, and erbium-doped fiber. The product has the advantages of high reliability, high power output, high gain and low noise. Two configurations are available: Pre-Amplifier for small optical signal amplification and Booster amplifier for maximum output power. We make both random polarization and polarization maintain versions. The compact module is suited for system integration with universal control interface. Remote control through GUI and UART is available, including power adjustment, input/output power monitoring, device temperature monitoring. The EDFA has isolators on both input and output.
Configuration options
Build & quote
Configure the options below and add your exact build to the enquiry — we confirm the part number and availability.
Part number: EDFA-AC211331
Type: Booster · Wavelength: 1535-1565nm · Power: 17dBm/50mW · Polarization: Random · Package: Component · Cable Type: 0.9mm tube · Fiber Length: 1.0m · Connector: None
System integration
Integration and compatibility
Use these checks to connect Wide Temperature EDFA Amplifier -40 to 70 °C to the surrounding optical, mechanical and control system. Every value shown is taken from this model's own specification record.
- Optical interface and fiber
- Fiber Length: 1.0m · Connector: None, FC/APC, Special
- Specify connector polish and fiber architecture together. FC/PC, FC/APC and SMA interfaces, and single-mode, multimode and polarization-maintaining fibers, impose different return-loss, mode-field and alignment requirements.
- Wavelength and loss budget
- Wavelength: 1535-1565nm, L Band, Red Band, Blue Band, Special
- Check the Fiber Optical Amplifiers EDFA passband, insertion loss, return loss and power handling at the actual source wavelength; a nominal telecom-band label is not a substitute for the configured range.
Technical FAQ
Integration questions for Wide Temperature EDFA Amplifier -40 to 70 °C
Which fiber and connector does the Wide Temperature EDFA Amplifier -40 to 70 °C use?
Fiber Length: 1.0m · Connector: None, FC/APC, Special. Specify connector polish and fiber architecture together. FC/PC, FC/APC and SMA interfaces, and single-mode, multimode and polarization-maintaining fibers, impose different return-loss, mode-field and alignment requirements.
How should the Wide Temperature EDFA Amplifier -40 to 70 °C be included in an optical power budget?
Wavelength: 1535-1565nm, L Band, Red Band, Blue Band, Special. Check the Fiber Optical Amplifiers EDFA passband, insertion loss, return loss and power handling at the actual source wavelength; a nominal telecom-band label is not a substitute for the configured range.
Need this configured?
Share your wavelength, fiber type, connector, power handling and control requirements and we will qualify the matching configuration and part number.
Model selection
Nearby series comparison
Compare Wide Temperature EDFA Amplifier -40 to 70 °C with the closest available models in the Fiber Optical Amplifiers EDFA family.
| Selection parameter | Wide Temperature EDFA Amplifier -40 to 70 °C (current) | Multiport EDFAs 1528-1565nm | Mini Erbium Doped Fiber Amplifier 1528-1565nm |
|---|---|---|---|
| Wavelength range | 1535-1565nm, L Band, Red Band, Blue Band, Special | 1550nm, Special | C Band, Special |
| Connector / control | None, FC/APC, Special | LC/PC, FC/PC, FC/APC, SC/PC, SC/APC, LC/APC | None, FC/APC, Special |
