Pulse energy, repetition rate, pulse width
HPL-532-PA532 nm green Q-switched high-power pulsed laser
532 nmThe HPL-532-PA is a 532 nm nanosecond diode-pumped solid-state laser. The specified pulse energy is 1–50 mJ. Select energy, timing and cooling for the same configuration. Laser diodes optically pump a solid gain medium inside a resonator. The pump supplies the energy; repeated passes through the gain medium amplify the laser light. Q-switching stores energy in the gain medium while resonator losses are high, then lowers those losses to release a pulse. Pulse energy and repetition rate must be considered together, because changing the pulse spacing changes the average power for a fixed pulse energy. At the nominal 200 Hz repetition rate, pulses lasting approximately 10 ns arrive about 5 ms apart. The quoted power range represents factory-set configurations; specify the required output rating when ordering.
Specifications
HPL-532-PA
16 specification rows
| Wavelength (nm) | 532 |
|---|---|
| Operating mode | Actively Q-switched |
| Pulse energy | 1–50 mJ |
| Repetition rate | 200 Hz |
| Pulse width | ~10 ns |
| Cooling | Water cooled |
| Average power | 1–10 W at 200 Hz |
| Power stability (rms, 4 hours±3℃) | <5%, <3% |
| Warm-up time(minutes) | <10 |
| Operating temperature (℃) | 15-35 |
| Power supply (220VAC) | PSU-HPL-PA*3 |
| Expected lifetime (hours) | >10000 |
| Peak power (MW) | 0.5-5 |
| Beam divergence, full angle (mrad) | <1 |
| Beam diameter at the aperture (1/e2,mm) | ~8 |
| Beam height from base plate (mm) | 71 |
Select energy and timing together
Specify pulse energy, repetition rate, pulse duration, trigger requirements and cooling for the same configuration. The maximum energy and maximum repetition rate can describe different variants. Energy per pulse is quoted in μJ, mJ or J; pulse duration is quoted in ps, ns or ms.
Compare high-energy laser models →What do you need?
Tell us the pulse energy, pulse width, repetition rate, trigger and cooling requirements you need, and we'll reply with the matching configuration and lead time.
Model selection
Nearby series comparison
Compare HPL-532-PA with the closest available models in the Pulsed Lasers family.
| Selection parameter | HPL-532-PA (current) | HPL-532-PB | HPL-532-Q |
|---|---|---|---|
| Wavelength | 532 nm | 532 nm | 532 nm |
| Optical power / pulse energy | 1–10 W at 200 Hz | 1–25 W at 500 Hz | 20-30 W |
| Operating mode / pulse width | Actively Q-switched | Actively Q-switched | Q-switched |
| Beam quality | <1 | <1 | <3.5 |
Related pulsed lasers
Compare the HPL-532-PA with nearby pulsed lasers across the wavelength range.
