Back to Home

Technology guide

Thermoelectric cooling: detector temperature and heat removal

Treat a TEC as a heat pump with a hot-side load, not a standalone source of a guaranteed detector temperature.

  1. 01Detector heat
  2. 02TEC
  3. 03Hot-side sink
  4. 04Ambient
Conceptual operating path.

How it works

  • A thermoelectric cooler transfers heat through the Peltier effect when electrical current flows. One side cools while the other side must reject heat.
  • The hot side carries the extracted detector heat plus electrical dissipation. Poor heat removal can prevent the detector from reaching its setpoint.
  • Temperature below ambient and absolute detector temperature are different specifications. Both depend on operating conditions and the selected air- or liquid-cooled configuration.
  • Cooling reduces temperature-dependent dark signal. It does not eliminate photon shot noise or amplifier read noise.

What to compare

ParameterCheck in the specification
Temperature ratingKeep ambient temperature, coolant conditions and detector load with a quoted cooling limit.
Heat rejectionConfirm the required fan clearance, heat sink or water circuit.
StabilitySeparate setpoint accuracy from temperature variation during an exposure.
CondensationCheck the manufacturer's sealed-chamber, window-heater or dry-gas provisions.

Integration

  • Use the cooling mode specified for the exact camera configuration.
  • Allow thermal settling before taking calibration frames or long measurements.
  • Verify coolant and environmental limits instead of extrapolating a nominal temperature drop to every laboratory condition.

Related products

  • MAX251AC-10G

    Detector assembly: IMX811AQR (C, RS).

  • Nightfall-LT

    Cooling assembly: Thermoelectric cooling; configuration dependent.

  • Nightfall-HR

    Detector assembly: Back-illuminated sCMOS.

References

Discuss the configuration. Send the wavelength, signal level, active area and bandwidth requirements.