Back to Home

Technology guide

Back-illuminated sensors: light path and response

Understand what back illumination changes and why coating, wavelength and operating mode still determine measured camera sensitivity.

  1. 01Incident light
  2. 02Rear surface
  3. 03Photosensitive region
  4. 04Readout
Conceptual operating path.

How it works

  • Back illumination places the light entrance on the rear side of the photosensitive structure. This reduces obstruction by front-side wiring and transistor structures.
  • The rear surface must still transmit and collect the wanted signal effectively. Surface preparation and optical coatings influence the response, especially near spectral limits.
  • Back illumination is compatible with several detector architectures. It does not establish CCD versus CMOS, shutter mode, cooling or a particular chip model.
  • Quantum efficiency describes photon-to-charge conversion. Camera signal-to-noise also includes background, dark signal and readout noise.

What to compare

ParameterCheck in the specification
QE curveCompare efficiency at the experiment wavelength rather than the highest value anywhere on the curve.
CoatingMatch UV, visible or near-infrared optimisation to the complete optical path.
Pixel samplingCheck pixel pitch and magnification before comparing collected signal per pixel.
Operating modeUse the noise and full-well figures for the selected readout and gain settings.

Integration

  • Include window, filter and lens transmission when estimating detected photons.
  • For quantitative imaging, distinguish sensor efficiency from end-to-end system collection efficiency.
  • Check strong-signal saturation and illumination uniformity as carefully as weak-signal sensitivity.

Related products

  • PHM2MPA

    Detector assembly: Sony IMX307(C) Starvis Back-illuminated CMOS 1/2.8" (5.57 × 3.13 mm).

  • CHARLIE

    Cooling assembly: Down to −50°C.

  • Nightfall-HR

    Detector assembly: Back-illuminated sCMOS.

References

Discuss the configuration. Send the wavelength, field of view, exposure and trigger requirements.