Technology guide
Q-switched lasers: stored energy and pulse release
Use pulse energy, repetition rate and cavity switching as a coupled operating specification.
- 01Pump energy
- 02Stored inversion
- 03Loss switching
- 04Pulse release
How it works
- Q-switching changes resonator loss so energy can accumulate in the gain medium before rapid extraction into a pulse.
- An active switch uses a controlled modulator; a passive implementation can use an intensity-dependent absorber. The actual mechanism must be identified in the model documentation.
- Pulse energy, duration and shape can change with repetition rate and pumping conditions. Maximum values listed separately are not necessarily simultaneously available.
- An external AOM that gates CW light does not automatically make the underlying laser Q-switched.
What to compare
| Parameter | Check in the specification |
|---|---|
| Pulse energy | Check energy at the specified repetition rate and output setting. |
| Duration definition | Keep FWHM, pulse shape and measurement conditions with the quoted width. |
| Triggering | Check command-to-pulse delay, jitter and accepted trigger patterns. |
| Average load | Include average optical power and cooling limits for continuous operation. |
Integration
- For illumination or processing, calculate pulse overlap from the real repetition sequence.
- Specify timing relative to the detector rather than only an electrical trigger frequency.
- Use the documented switch type when planning modulation or synchronization hardware.
Related products
- TUN-TiA-770-840
Head cooling: Water Cooled.
- AO-532A & 355A
Head cooling: Air cooled.
- HPL-440-QM
Head cooling: Water Cooled.
References
Discuss the configuration. Send the wavelength, output, pulse or CW mode and control requirements.