Back to Home

Technology guide

Gain-switched lasers: electrical excitation and optical pulses

Evaluate the electrical drive and optical pulse together when the gain is driven through the lasing threshold.

  1. 01Current pulse
  2. 02Gain buildup
  3. 03Lasing threshold
  4. 04Optical pulse
Conceptual operating path.

How it works

  • Gain switching varies excitation rapidly enough to move the laser through threshold and generate short optical bursts.
  • The optical pulse does not simply copy the electrical waveform. Carrier dynamics, operating bias and resonator behaviour affect delay and shape.
  • Pulse width, timing jitter, spectral behaviour and energy depend on the selected drive conditions. Changing repetition rate can change the optical result.
  • Gain switching is different from changing cavity loss in a Q-switch and from imposing phase relationships in mode locking.

What to compare

ParameterCheck in the specification
Electrical inputCheck bias, pulse amplitude, edge speed and the documented control termination.
Optical timingCompare trigger delay and jitter at the intended operating point.
Pulse energyKeep repetition rate and average output with the measurement.
Spectral outputConfirm linewidth, chirp and side modes where the measurement requires them.

Integration

  • Use the actual laser-driver pair rather than treating a modulation input as unrestricted access to the diode current.
  • Match the detector bandwidth to the optical pulse being measured.
  • Retain manufacturer operating conditions when comparing short-pulse specifications.

References

Discuss the configuration. Send the wavelength, output, pulse or CW mode and control requirements.