Setting beam height
Hold every optic in a path at one consistent deck height so components can be swapped without realignment.
Posts and Post Holders · PHCP Series Crossing Post Clamp
PHCP-1
PHCP Series Crossing Post Clamp
PHCP series crossing Post clamps are used to link and fix different posts so that the angle between the two posts reaches the desired value, and posts can be fixed by fastening thumb screws.
Datasheet (PDF) ↗Catalog context
Where PHCP-1 fits
PHCP-1 is listed as PHCP Series Crossing Post Clamp in the PHCP Series Crossing Post Clamp family. Use the product-family page and any model-specific downloads available here to confirm the required configuration.
Specifications
Full specifications for this product are available on request. Contact us for the datasheet.
Application context
Why this design is used
Application guidance is derived from the product family and tied to the model-specific selection fields above.
Mounting optics to the table
The structural link between an optic and the breadboard, where stiffness decides how well alignment survives.
Rapid reconfiguration
Slide-and-clamp holders let a layout be rebuilt without unbolting the whole assembly.
Model selection
Nearby series comparison
Compare PHCP-1 with the closest available models in the PHCP Series Crossing Post Clamp family. Confirm option-dependent values on the final configuration before ordering.
| Selection parameter | PHCP-1 (current) | PHCP-2 | PHCP12-4H |
|---|---|---|---|
| Optic accepted | Confirm for this model | Confirm for this model | Confirm for this model |
| Adjustment | Confirm for this model | Confirm for this model | Confirm for this model |
| Mounting interface | Confirm for this model | Confirm for this model | Confirm for this model |
| Material | Confirm for this model | Confirm for this model | Confirm for this model |
