Back to Home

Technology guide

Thin-film optical filters: coatings, angle and bandwidth

Specify the transmitted and rejected bands together with incidence angle, polarization and beam geometry.

  1. 01Incident spectrum
  2. 02Coating layers
  3. 03Interference
  4. 04Selected band
Conceptual operating path.

How it works

  • A thin-film interference filter uses multiple optical layers to produce wavelength-dependent transmission and reflection.
  • Layer design, material dispersion and incidence geometry set the response. A filter's nominal centre wavelength does not fully describe its passband or blocking.
  • Tilting changes the optical path through the coating and can shift the spectral response. A converging beam samples a range of incidence angles.
  • Polarization can affect response at non-normal incidence. Substrate and coating performance must both match the experiment's spectral and power conditions.

What to compare

ParameterCheck in the specification
PassbandKeep centre wavelength, width, shape and peak transmission together.
BlockingDefine the rejected range and optical density or transmission limit.
GeometryState incidence angle, beam cone and polarization.
Mechanical fitCheck clear aperture, thickness and holder compatibility.

Integration

  • Include filter transmission in the signal budget and check unwanted source lines separately.
  • Use the specified orientation and incidence conditions.
  • Do not transfer a curve measured in a collimated normal-incidence beam to a fast converging beam without checking the difference.

Related products

References

Discuss the configuration. Send the wavelength, beam or image geometry and mechanical interfaces.