Technology guide
Image intensifiers: photocathodes, gain and gating
Select the photocathode, multiplication stage and output screen as one detection chain for weak or time-gated optical signals.
- 01Light
- 02Photocathode
- 03Electron gain
- 04Phosphor image
How it works
- An image intensifier converts incoming light to electrons at a photocathode. An electron multiplication stage increases the signal before a phosphor converts it back to an optical image.
- The photocathode sets much of the wavelength response. A camera sensor behind the intensifier does not define the complete system spectral efficiency.
- Microchannel-plate configuration, gain and phosphor affect resolution, dynamic range and temporal response. Their values belong to the selected intensifier build.
- Gating controls the sensitive interval, while phosphor decay and camera readout affect the recorded sequence. Minimum gate width is not the same as sustained frame rate.
What to compare
| Parameter | Check in the specification |
|---|---|
| Input size | Match the intensifier active diameter to the optical image and relay magnification. |
| Photocathode | Choose its response curve for the signal wavelength and available background. |
| Gain | Check saturation and spatial resolution at the intended amplification setting. |
| Timing | Keep gate width, repetition rate, trigger delay and output persistence separate. |
Integration
- Confirm how the intensifier is coupled to the camera and whether that optical arrangement is included.
- Specify photocathode, MCP configuration and phosphor together.
- For pulsed work, budget timing jitter across the source, trigger electronics, intensifier and camera.
Related products
References
Discuss the configuration. Send the wavelength, signal level, active area and bandwidth requirements.