Technology guide
EMCCD cameras: multiplication gain and its limits
Use electron multiplication when the signal needs amplification before readout, while accounting for gain noise, saturation and calibration.
- 01Photons
- 02CCD transfer
- 03Gain register
- 04Readout
How it works
- An EMCCD adds a high-field multiplication register to a CCD. Charge is amplified through repeated multiplication stages before reaching the output amplifier.
- This gain can make downstream read noise less important when referred back to the detector input. It does not increase the number of photons collected by the sensor.
- Multiplication is stochastic. Analogue operation therefore introduces an excess-noise contribution, and the usable dynamic range changes with gain.
- Dark signal and clock-induced charge also matter in weak-signal work. Detector temperature, clock settings and exposure conditions must accompany a sensitivity comparison.
What to compare
| Parameter | Check in the specification |
|---|---|
| EM gain | Choose enough gain for the signal regime; maximum gain is not automatically the best quantitative setting. |
| Photon flux | Separate sparse-event photon counting from analogue imaging with several photoelectrons per pixel. |
| Saturation | Check both the image area and multiplication register limits at the selected gain. |
| Calibration | Confirm gain stability, background measurement and the method used to convert output counts to input electrons. |
Integration
- Compare an EMCCD with CMOS at the same photon flux, sampling and acquisition time.
- Use the specified detector cooling and allow the camera to reach its calibrated operating condition.
- Check binning, region-of-interest and readout settings before transferring a noise specification into a measurement budget.
References
Discuss the configuration. Send the wavelength, field of view, exposure and trigger requirements.