Back to Home

Technology guide

Erbium-doped fiber amplifiers: gain, noise and saturation

Choose an EDFA around the signal band, input level and required output, including amplified spontaneous emission.

  1. 01Pump light
  2. 02Erbium-doped fiber
  3. 03Signal gain
  4. 04Amplified output
Conceptual operating path.

How it works

  • An EDFA uses pump light to excite erbium ions in an active fiber. A signal in the supported band is amplified by stimulated emission.
  • The amplifier does not require a laser resonator around the signal path. Optical gain and laser oscillation are different functions.
  • Gain depends on input signal, pump conditions and saturation. Small-signal gain and maximum saturated output are not simultaneously interchangeable specifications.
  • Amplified spontaneous emission adds optical background. Filters and the receiving instrument's bandwidth influence the measured signal-to-noise ratio.

What to compare

ParameterCheck in the specification
Signal bandUse the specified gain band and wavelength-dependent gain curve.
Input rangeCheck required signal level, maximum input and handling of absent input.
Output and gainKeep saturation and gain-control mode with the value.
Noise and polarizationCompare noise figure, ASE and polarization dependence under equivalent conditions.

Integration

  • State whether the amplifier is used as a preamplifier, booster or in-line stage.
  • Check fiber type, connectors and optical isolation requirements.
  • Confirm pump electronics, control interface and monitoring when comparing a bare module with an enclosed amplifier.

Related products

References

Discuss the configuration. Send the wavelength, optical levels, port topology and fiber interfaces.