Set-and-forget alignment
Adjust once during setup and lock, on axes that do not need to move again during the run.
Opto-Mechanics · Fiber Alignment Accessories
APFP-FH
APFP-FH bare-fiber holder
Magnetic clamp for holding 125 µm bare single-mode fiber on APFP-compatible dovetail stages.
Datasheet (PDF) ↗Catalog context
Where APFP-FH fits
APFP-FH is listed as APFP-FH bare-fiber holder in the Fiber Alignment Accessories family. The local catalog record provides these first selection fields: Type: Bare-fiber holder; Nominal fiber diameter: 125 µm; Clamp: Magnetic, side-release.
Specifications
| Type | Bare-fiber holder |
|---|---|
| Nominal fiber diameter | 125 µm |
| Clamp | Magnetic, side-release |
| Base | APFP dovetail |
Application context
Why this design is used
Application guidance is derived from the product family and tied to the model-specific selection fields above.
Coarse positioning ahead of fine stages
Establish the optical axis by hand before a piezo or motorised stage takes the fine motion.
Prototyping and teaching rigs
Reconfigure a layout quickly, with no cabling, controllers or electrical noise added to the experiment.
Model selection
Nearby series comparison
Compare APFP-FH with the closest available models in the Fiber Alignment Accessories family. Confirm option-dependent values on the final configuration before ordering.
| Selection parameter | APFP-FH (current) | APFP-FC | APFP-GB |
|---|---|---|---|
| Optic accepted | Confirm for this model | Confirm for this model | Confirm for this model |
| Adjustment | Confirm for this model | Confirm for this model | Confirm for this model |
| Mounting interface | Confirm for this model | Confirm for this model | Confirm for this model |
| Material | Confirm for this model | Confirm for this model | Confirm for this model |
